Will Latex Paint Stick To Vinyl

Apply primer if necessary then two coats of paint.

Will latex paint stick to vinyl.

Do not use poor quality latex or oil based paints. If your vinyl surface is clean the paint or primer will adhere to the vinyl rather than the dirt and you will have a longer lasting finish. Prepare the vinyl surface by cleaning it thoroughly. A paint that sets too hard cannot withstand the stresses of that environment.

Sanding or removal of paint containing lead is hazardous. Using a deglossing product removes the vinyl floor s gloss which allows the paint to more readily adhere to the surface. Acrylic paint remains very flexible. Several paint companies make a specifically formulated base for this task.

Choose a latex urethane paint that can flex with the siding. In that case vinyl trim can be painted using latex paint. The expansion and contraction vinyl experiences throughout the year creates the biggest challenge for paint formulators. Avoid lower cost latex paint.

It s also vital that you choose the correct paint. There are some specific types of paint that work best for flexible vinyl. The best paint for vinyl is water based 100 percent acrylic paint or urethane modified acrylic paint. Paint will not stick to a dirty surface.

You can also use a primer between the vinyl and the paint. While kilz adhesion primer is formulated to bond without sanding it is recommended that a small area be tested for adhesion prior to beginning the job. Paints that are mostly acrylic based are the best as they stick to the vinyl better without cracking or chipping off. Choose an exterior paint made entirely of acrylic latex and.

Vinyl can expand and contract significantly with temperature changes and lower quality paint will crack and peel under the stress. Urethane modified acrylic paint also works well. Choose the proper paint latex urethane formulated for outdoor use. Mold or mildew covered surfaces.

Vinyl expands in heat and contracts in the cold so it needs a paint that can stretch and shrink without splitting or losing adhesion. Wash the area with a mildew remover rinse with water and allow to dry before priming.